Norm

ASTM B311-13

Standard Test Method for Density of Powder Metallurgy (PM) Materials Containing Less Than Two Percent Porosity

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie B09.11
Gepubliceerd op 01-04-2013
Taal Engels

1.1 This test method covers the determination of density for powder metallurgy (PM) materials containing less than two percent porosity and for cemented carbides. This test method is based on the water displacement method.

Note 1A test specimen that gains mass when immersed in water indicates the specimen contains surface-connected porosity. Unsealed surface porosity will absorb water and cause density values higher than the true value. This test method is not applicable if this problem occurs.

1.2 With the exception of the values for density and the mass used to determine density, for which the use of the gram per cubic centimeter (g/cm3) and gram (g) units is the long-standing industry practice, the values in SI units are to be regarded as standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.160
Nederlandse titel Standard Test Method for Density of Powder Metallurgy (PM) Materials Containing Less Than Two Percent Porosity
Engelse titel Standard Test Method for Density of Powder Metallurgy (PM) Materials Containing Less Than Two Percent Porosity

Winkelwagen

Subtotaal:

Ga naar winkelwagen