Over deze norm
1.1 This specification covers wire and rod in the alloys ( ) shown in Table 1 and the tempers shown in Table 2 [Table 3] and Table 4 [Table 5], suitable for manufacturing rivets and other similar items by cold-heading operations.
Note 1: Throughout this specification the use of the term alloy in the general sense includes aluminum as well as aluminum alloy.
Note 2: For rolled or cold-finished wire and rod, see Specification , and for extruded wire and rod, see Specification .
1.2 Alloy and temper designations are in accordance with ANSI H35.1/H35.1M. The equivalent Unified Numbering System alloy designations are those of Table 1 preceded by A9, for example, A91100 for aluminum 1100 in accordance with Practice .
1.3 For acceptance criteria for inclusion of new aluminum and aluminum alloys in this specification, see .
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4.1 The SI units are shown either in brackets or in separate tables.
|Nederlandse titel||Standard Specification for Aluminum and Aluminum-Alloy Rivet and Cold-Heading Wire and Rods|
|Engelse titel||Standard Specification for Aluminum and Aluminum-Alloy Rivet and Cold-Heading Wire and Rods|