Norm

ASTM B355 - 11 en

Standard Specification for Nickel-Coated Soft or Annealed Copper Wire

  • Deze norm is ingetrokken sinds 01-10-2016

50,60 61,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 8
Gepubliceerd op 01-04-2011
Taal Engels

1.1 This specification covers nickel-coated, soft or annealed, round copper wire for use in electrical equipment.

1.2 Five classes of wire are covered as follows:

1.2.1 Class 2Wire whose nickel coating is at least 2 % of the total weight of the coated wire.

1.2.2 Class 4Wire whose nickel coating is at least 4 % of the total weight of the coated wire.

1.2.3 Class 7Wire whose nickel coating is at least 7 % of the total weight of the coated wire.

1.2.4 Class 10Wire whose nickel coating is at least 10 % of the total weight of the coated wire.

1.2.5 Class 27Wire whose nickel coating is at least 27 % of the total weight of the coated wire.

Note 1—For information purposes, the thickness of coating in microinches provided by the percentages listed in 1.2 is shown in Table 1.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parenthesis are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3.1 ExceptionsThe SI values for density, resistivity, and volume are to be regarded as standard.

1.4 This hazard statement applies only to Section 6, Test Methods, and to the Appendix of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.150.30
Engelse titel Standard Specification for Nickel-Coated Soft or Annealed Copper Wire
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen