ASTM B359/B359M - 12 en

Standard Specification for Copper and Copper-Alloy Seamless Condenser and Heat Exchanger Tubes With Integral Fins

  • Deze norm is ingetrokken sinds 01-04-2012

57,20 69,21 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 11
Gepubliceerd op 01-04-2012
Taal Engels

1.1 This specification establishes the requirements for seamless copper and copper alloy tubing on which the external or internal surface, or both, has been modified by a cold-forming process to produce an integral enhanced surface for improved heat transfer.

1.2 UnitsThe values stated in either in-pound units or SI units are to be regarded separately as the standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems could result in nonconformance with the specification.

1.3 The tubes are typically used in surface condensers, evaporators, and heat exchangers.

1.4 The product shall be produced of the following coppers or copper alloys, as specified in the ordering information.

Copper or Copper Alloy
Type of Metal
C10100Oxygen-free electronic
C10200Oxygen-free without residual deoxidants
C10300Oxygen-free, extra low phosphorus
C10800Oxygen-free, low phosphorus
C12000DLP Phosphorized, low residual phosphorus
(See Note 1)
C12200DHP, Phosphorized, high residual phosphorus
(See Note 1)
C14200DPA Phosphorized arsenical
(See Note 1)
C19200Phosphorized, 1 % iron
C23000Red Brass
C44300Admiralty Metal Types B,
C44400C, and
C60800Aluminum Bronze
C68700Aluminum Brass Type B
C7040095-5 Copper-Nickel
C7060090-10 Copper-Nickel
C7062090-10 Copper-Nickel (Modified for Welding)
C7100080-20 Copper-Nickel Type A
C7150070-30 Copper-Nickel
C7152070-30 Copper-Nickel (Modified for Welding)

Note 1—Designations listed in Classification B224.

1.5 The following safety hazard caveat pertains only to the test methods described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.6 Product produced in accordance with the Supplementary Requirements section for military applications shall be produced only to the inch-pound system of this specification.


ICS-code 23.040.15
Engelse titel Standard Specification for Copper and Copper-Alloy Seamless Condenser and Heat Exchanger Tubes With Integral Fins
Vervangen door



Ga naar winkelwagen