Norm

ASTM B457-67(2013)

Standard Test Method for Measurement of Impedance of Anodic Coatings on Aluminum

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie B08.07
Gepubliceerd op 01-05-2013
Taal Engels

1.1 This test method describes the conditions and equipment for measuring the impedance of anodic coatings on aluminum. Such measurements have been used to evaluate the quality of seal of an anodic coating. The test method does not prescribe the procedure for producing the anodic coating, nor the postanodizing treatment usually described as “sealing.”

1.2 This test method is applicable to the rapid, nondestructive testing of anodic coatings. The interpretation of results and correlation of data with service experience and other tests are not within the scope of this test method.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 25.220.20
Nederlandse titel Standard Test Method for Measurement of Impedance of Anodic Coatings on Aluminum
Engelse titel Standard Test Method for Measurement of Impedance of Anodic Coatings on Aluminum

Winkelwagen

Subtotaal:

Ga naar winkelwagen