Norm

ASTM B505/B505M - 18 en

Standard Specification for Copper Alloy Continuous Castings

50,60 61,23 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 10
Gepubliceerd op 01-03-2018
Taal Engels

1.1 This specification establishes requirements for continuously cast rod, bar, tube, and shapes produced from copper alloys with nominal compositions as listed in Table 1.2

(A) Antimony 0.07, Boron 0.001.

1.2 Castings produced to this specification may be manufactured for and supplied from stock. In such cases the manufacturer shall maintain heat traceability to specific manufacturing date and chemical analysis.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 77.150.30
Engelse titel Standard Specification for Copper Alloy Continuous Castings
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen