Norm

ASTM B533-85(2013)

Standard Test Method for Peel Strength of Metal Electroplated Plastics

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie B08.05
Gepubliceerd op 01-12-2013
Taal Engels

1.1 This test method gives two procedures for measuring the force required to peel a metallic coating from a plastic substrate.2 One procedure (Procedure A) utilizes a universal testing machine and yields reproducible measurements that can be used in research and development, in quality control and product acceptance, in the description of material and process characteristics, and in communications. The other procedure (Procedure B) utilizes an indicating force instrument that is less accurate and that is sensitive to operator technique. It is suitable for process control use.

1.2 The tests are performed on standard molded plaques. This method does not cover the testing of production electroplated parts.

1.3 The tests do not necessarily measure the adhesion of a metallic coating to a plastic substrate because in properly prepared test specimens, separation usually occurs in the plastic just beneath the coating-substrate interface rather than at the interface. It does, however, reflect the degree that the process is controlled.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 25.220.40
Nederlandse titel Standard Test Method for Peel Strength of Metal Electroplated Plastics
Engelse titel Standard Test Method for Peel Strength of Metal Electroplated Plastics

Winkelwagen

Subtotaal:

Ga naar winkelwagen