Norm

ASTM B582-07(2013)

Standard Specification for Nickel-Chromium-Iron-Molybdenum-Copper Alloy Plate, Sheet, and Strip

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie B02.07
Gepubliceerd op 01-02-2013
Taal Engels

1.1 The specification2 covers plate, sheet, and strip of nickel-chromium-iron-molybdenum-copper alloys (UNS N06007, N06975, N06985, and N06030)* as shown in Table 1, for use in general corrosive service.

TABLE 1 Chemical Requirements

Element

Composition Limits, %

 

Alloy N06007

Alloy N06975

Alloy N06985

Alloy N06030

Nickel

 

remainderA

47.0 to 52.0

remainderA

remainderA

Chromium

 

21.0 to 23.5

23.0 to 26.0

21.0 to 23.5

28.0 to 31.5

Iron

 

18.0 to 21.0

remainderA

18.0 to 21.0

13.0 to 17.0

Molybdenum

 

5.5 to 7.5

5.0 to 7.0

6.0 to 8.0

4.0 to 6.0

Copper

 

1.5 to 2.5

0.70 to 1.20

1.5 to 2.5

1.0 to 2.4

Manganese

 

1.0 to 2.0

1.0 max

1.0 max

1.5 max

Cobalt, max

 

2.5

...

5.0

5.0

Carbon, max

 

0.05

0.03

0.015

0.03

Tungsten

 

1.0 max

...

1.5 max

1.5 to 4.0

Silicon, max

 

1.0

1.0

1.0

0.8

Phosphorus, max

 

0.04

0.03

0.04

0.04

Sulfur, max

 

0.03

0.03

0.03

0.02

Columbium + tantalum

 

1.75 to 2.50

...

0.50 max

0.30 to 1.50

Titanium

 

...

0.70–1.50

...

...

A The composition of the remainder element shall be determined arithmetically by difference.

1.2 The following products are covered under this specification:

1.2.1 Sheet and Strip—Hot or cold rolled, solution annealed, and descaled unless solution anneal is performed in an atmosphere yielding a bright finish.

1.2.2 Plate—Hot or cold rolled, solution annealed, and descaled.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.150.40
Nederlandse titel Standard Specification for Nickel-Chromium-Iron-Molybdenum-Copper Alloy Plate, Sheet, and Strip
Engelse titel Standard Specification for Nickel-Chromium-Iron-Molybdenum-Copper Alloy Plate, Sheet, and Strip

Winkelwagen

Subtotaal:

Ga naar winkelwagen