Norm

ASTM B589 - 94(2017) en

Standard Specification for Refined Palladium

45,11 54,58 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 2
Gepubliceerd op 01-11-2017
Taal Engels

1.1 This specification covers refined palladium as sponge, cast bar, and wrought forms (Note 1) in one grade as follows:

1.1.1 Grade 99.95 (UNS PO3995)—Palladium having a purity of 99.95 %.

Note 1: Other forms of unfabricated palladium of commerce are not to be excluded under this specification.

Note 2: For the purposes of determining conformance with this specification, an observed value obtained from analysis shall be rounded to the nearest unit in the last right hand place of figures used in expressing the limiting value, in accordance with the rounding method of Practice E29.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety, health, and environmental practices, and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 77.120.99
Engelse titel Standard Specification for Refined Palladium
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen