Norm

ASTM B593-96(2014)e1

Standard Test Method for Bending Fatigue Testing for Copper-Alloy Spring Materials

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie B05.06
Gepubliceerd op 01-04-2009
Taal Engels

1.1 This test method establishes procedures for the determination of the reversed or repeated bending fatigue properties of copper alloy flat-sheet or strip-spring materials by fixed cantilever, constant deflection (that is, constant amplitude of displacement)-type testing machines. This method is limited to flat stock ranging in thickness from 0.005 to 0.062 in. (0.13 to 1.57 mm), to a fatigue-life range of 105 to 108 cycles, and to conditions where no significant change in stress-strain relations occurs during the test.

Note 1: This implies that the load-deflection characteristics of the material do not change as a function of the number of cycles within the precision of measurement. There is no significant cyclic hardening or softening.

1.2 Units—The values stated in inch-pound units are to be regarded as standard. Values given in parentheses are mathematical conversions to SI units which are provided for information only and are not considered standard.

1.3 The following safety hazard caveat pertains only to the test methods(s) described in this test method.

1.3.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.150.30
Nederlandse titel Standard Test Method for Bending Fatigue Testing for Copper-Alloy Spring Materials
Engelse titel Standard Test Method for Bending Fatigue Testing for Copper-Alloy Spring Materials

Winkelwagen

Subtotaal:

Ga naar winkelwagen