Norm

ASTM B647 - 10 en

Standard Test Method for Indentation Hardness of Aluminum Alloys by Means of a Webster Hardness Gage

  • Deze norm is ingetrokken sinds 01-05-2016

45,11 54,58 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 4
Gepubliceerd op 01-12-2010
Taal Engels

1.1 This test method covers the determination of indentation hardness of aluminum alloys with a Webster hardness gage, Model B.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.2.1 ExceptionThe values given in parentheses are for information only.

Note 1—Two other models, A and B-75, are in use, but are not covered in this test method. Model A does not provide numerical values of hardness and Model B-75 covers only a part of the range of interest for aluminum alloys.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.120.10
Engelse titel Standard Test Method for Indentation Hardness of Aluminum Alloys by Means of a Webster Hardness Gage
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen