Norm

ASTM B680-80(2014)

Standard Test Method for Seal Quality of Anodic Coatings on Aluminum by Acid Dissolution

48,24

Over deze norm

Status Definitief
Aantal pagina's 2
Commissie B08.07
Gepubliceerd op 01-11-2014
Taal Engels

1.1 This test method covers a test for the quality of seal of porous anodic coatings on aluminum and its alloys. It is based upon the loss in mass of the coating after immersion in a warm phosphoric-chromic acid solution.

1.2 This test method is applicable to anodic coatings intended for exposure to the weather, or for protective purposes in corrosive media, and where resistance to staining is important.

1.3 This test method is not applicable to:

1.3.1 Hard coatings, which normally are not sealed.

1.3.2 Anodic coatings that have been sealed only in dichromate solutions.

1.3.3 Anodic coatings that have undergone a treatment to render them hydrophobic.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 25.220.40
Nederlandse titel Standard Test Method for Seal Quality of Anodic Coatings on Aluminum by Acid Dissolution
Engelse titel Standard Test Method for Seal Quality of Anodic Coatings on Aluminum by Acid Dissolution

Winkelwagen

Subtotaal:

Ga naar winkelwagen