ASTM B69-13

Standard Specification for Rolled Zinc


Over deze norm

Status Definitief
Aantal pagina's 5
Commissie B02.04
Gepubliceerd op 01-02-2013
Taal Engels

1.1 This specification covers two types of commercial rolled zinc as described in 1.2. It should be understood that the specification is general. Any closer limitations on permissible variations shall be a matter of agreement between the supplier (manufacturer) and the purchaser.

1.2 Rolled zinc is furnished in two types as follows:

1.2.1 Type I—Coils or sheets cut from strip (ribbon) rolled zinc and

1.2.2 Type II—Coils or sheets cut from strip (ribbon) rolled zinc.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.


ICS-code 77.120.60
Nederlandse titel Standard Specification for Rolled Zinc
Engelse titel Standard Specification for Rolled Zinc



Ga naar winkelwagen