Norm

ASTM B737-10(2015)

Standard Specification for Hot-Rolled and/or Cold-Finished Hafnium Rod and Wire

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie B10.02
Gepubliceerd op 01-05-2015
Taal Engels

1.1 This specification covers hot- or cold-worked hafnium rod and wire.

1.2 This specification contains two material grades, one specifically for nuclear applications (Grade R1) and one for commercial alloying applications (Grade R3).

1.3 The products covered include the following:

1.3.1 Rod 3/8 to 1 in. (9.5 to 25 mm) in diameter.

1.3.2 Wire less than 3/8 in. (9.5 mm) in diameter.

1.4 Unless a single unit is used, for example, corrosion mass gain in mg/dm2, the values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. SI values cannot be mixed with inch-pound values.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.150.99
Nederlandse titel Standard Specification for Hot-Rolled and/or Cold-Finished Hafnium Rod and Wire
Engelse titel Standard Specification for Hot-Rolled and/or Cold-Finished Hafnium Rod and Wire

Winkelwagen

Subtotaal:

Ga naar winkelwagen