Norm

ASTM B756 - 00(2011) en

Standard Specification for Nickel-Chromium-Molybdenum-Tungsten Alloy
(UNS N06110) Rod and Bar

  • Deze norm is ingetrokken sinds 01-06-2016

50,60 61,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 5
Gepubliceerd op 01-10-2011
Taal Engels

1.1 This specification covers nickel-chromium-molybdenum-tungsten (UNS N06110) in the form of hot-worked rod and bar and cold-worked rod in the conditions shown in Table 1.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

TABLE 1 Mechanical Properties

Condition and Diameter
or Distance Between
Parallel Surfaces in.
(mm)
Tensile
Strength
min, ksi
(MPa)
Yield
Strength
(0.2%
Offset),
min, ksi
(MPa)
Elongation
in 2 in.
or 50 mm
or 4D, min,
%
Cold-worked rods and
hot-worked rod and bar,
annealed:
Up to 4 (102), incl95 (655)45 (310)60
Over 4 (102) to 10 (254), incl90 (621) 40 (276)50
Forging quality (all sizes)AAA

A Forging quality is furnished to chemical requirements and surface inspection only. No tensile properties are required.

Details

ICS-code 77.150.40
Engelse titel Standard Specification for Nickel-Chromium-Molybdenum-Tungsten Alloy
(UNS N06110) Rod and Bar
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen