Over deze norm
1.1 This specification establishes the requirements for seamless round, rectangular, and square copper tube suitable for general engineering applications.
1.1.1 Tubes made from any of the following Copper UNS No. designations shall be supplied unless otherwise specified in the contract or purchase order:
|Copper UNS No.||Type of Copper|
|C10200||Oxygen-free without residual deoxidants|
|C10300||Oxygen-free, extra low phosphorus|
|C10800||Oxygen-free, low phosphorus|
|C12000||Phosphorus deoxidized, low residual phosphorus|
|C12200||Phosphorus deoxidized, high residual phosphorus|
1.2 Units—The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 The following hazard statement pertains only to the test methods described in Sections 184.108.40.206, 21.2.9, and 21.2.10 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
|Nederlandse titel||Standard Specification for Seamless Copper Tube|
|Engelse titel||Standard Specification for Seamless Copper Tube|