Norm

ASTM B792 - 12 en

Standard Specification for Zinc Alloys in Ingot Form for Slush Casting

  • Deze norm is ingetrokken sinds 01-02-2013

45,11 54,58 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 2
Gepubliceerd op 01-05-2012
Taal Engels

1.1 This specification covers commercial zinc alloys in ingot form for remelting for the manufacture of castings from the alloys as specified and designated as shown in Table 1.

1.2 Slush casting alloys are used primarily for the manufacture of hollow castings such as lighting fixtures, lamp bases, and small statues.

1.3 This specification covers two zinc alloys which are specified and designated as follows:

UNSASTM
Z34510Slush Casting Alloy A
Z30500Slush Casting Alloy B

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

TABLE 1 Chemical and North American Color Code RequirementsA,B

Composition, %
UNS Z34510
Slush Casting Alloy A
UNS Z30500
Slush Casting Alloy B
Color CodeCBlack/RedBlack/Orange
Element
Copper 0.20.3 0.1 max
Aluminum4.505.00 5.255.75
Lead 0.007 max0.007 max
Cadmium 0.005 max0.005 max
Tin 0.005 max0.005 max
Iron 0.100 max0.100 max
Magnesium0.010 max0.010 max
Zinc RemainderRemainder

A The following applies to all specified limits in this table. For purposes of determining conformance with this specification, the observed or calculated value obtained from analysis shall be rounded off to the nearest unit in the last right-hand place of figures used in expressing the specified limit, in accordance with the rounding method of Practice E29.

B UNS designations were established in accordance with Practice E527.

C Refer to Practice B908. (Note: Colors indicated are for North American applications.)

Details

ICS-code 77.150.60
Engelse titel Standard Specification for Zinc Alloys in Ingot Form for Slush Casting
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen