Norm

ASTM B883-15

Standard Specification for Metal Injection Molded (MIM) Materials

54,27

Over deze norm

Status Definitief
Aantal pagina's 7
Commissie B09.11
Gepubliceerd op 01-10-2015
Taal Engels

1.1 This specification covers ferrous metal injection molded materials fabricated by mixing elemental or pre-alloyed metal powders with binders, injecting into a mold, debinding, and sintering, with or without subsequent heat treatment.

1.2 This specification covers the following injection molded materials.

1.2.1 Compositions: 

1.2.1.1 MIM-2200, low-alloy steel

1.2.1.2 MIM-2700, low-alloy steel

1.2.1.3 MIM-4605, low-alloy steel

1.2.1.4 MIM-4140, low-alloy steel

1.2.1.5 MIM-316L, austenitic stainless steel

1.2.1.6 MIM-17-4 PH, precipitation hardening stainless steel

1.2.1.7 MIM-420, ferritic stainless steel

1.2.1.8 MIM-430L, ferritic stainless steel

1.2.1.9 MIM-Cu, copper

1.3 Chemical composition limits are specified in Table 1.

(A) Excluding silver.

1.4 With the exception of the values for density and the mass used to determine density, for which the use of the gram per cubic centimetre (g/cm3) and gram (g) units is the longstanding industry practice, the values in inch-pound units are to be regarded as standard. The values given in parentheses or in separate tables are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.140.80
77.160
Nederlandse titel Standard Specification for Metal Injection Molded (MIM) Materials
Engelse titel Standard Specification for Metal Injection Molded (MIM) Materials

Winkelwagen

Subtotaal:

Ga naar winkelwagen