Norm

ASTM B997-16

Standard Specification for Zinc-Aluminum Alloys in Ingot Form for Hot-Dip Coatings

44,21

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie B02.04
Gepubliceerd op 01-05-2016
Taal Engels

1.1 This specification covers certain zinc-aluminum (Zn-Al) alloys in ingot form for re-melting for use in the production of hot-dip coatings on steel. Alloy compositions are specified below and in Table 1.

ASTM

Common

UNS

Type 5

95/5 Zn/Al

to be assigned

Type 10

90/10 Zn/Al

to be assigned

Type 15

85/15 Zn/Al

to be assigned

Note 1: The zinc-aluminum alloys in Specification B997 are intended to be used primarily to create a molten zinc-aluminum bath and differ from the master alloys in Specification B860 which are intended primarily to adjust the concentration of certain elements in molten zinc galvanizing baths.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

Nederlandse titel Standard Specification for Zinc-Aluminum Alloys in Ingot Form for Hot-Dip Coatings
Engelse titel Standard Specification for Zinc-Aluminum Alloys in Ingot Form for Hot-Dip Coatings

Winkelwagen

Subtotaal:

Ga naar winkelwagen