Norm

ASTM C1046-95(2013)

Standard Practice for In-Situ Measurement of Heat Flux and Temperature on Building Envelope Components

54,27

Over deze norm

Status Definitief
Aantal pagina's 10
Commissie C16.30
Gepubliceerd op 01-11-2013
Taal Engels

1.1 This practice covers a technique for using heat flux transducers (HFTs) and temperature transducers (TTs) in measurements of the in-situ dynamic or steady-state thermal behavior of opaque components of building envelopes. The applications for such data include determination of thermal resistances or of thermal time constants. However, such uses are beyond the scope of this practice (for information on determining thermal resistances, see Practice C1155).

1.2 Use infrared thermography with this technique to locate appropriate sites for HFTs and TTs (hereafter called sensors), unless subsurface conditions are known.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 91.100.99
Nederlandse titel Standard Practice for In-Situ Measurement of Heat Flux and Temperature on Building Envelope Components
Engelse titel Standard Practice for In-Situ Measurement of Heat Flux and Temperature on Building Envelope Components

Winkelwagen

Subtotaal:

Ga naar winkelwagen