Norm

ASTM C1197-14a

Standard Test Method for In Situ Measurement of Masonry Deformability Properties Using the Flatjack Method

54,27

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie C15.04
Gepubliceerd op 01-12-2014
Taal Engels

1.1 This test method describes an in situ method for determining the deformation properties of existing unreinforced solid-unit masonry. (See Note 1.) This test method concerns the measurement of in-situ masonry deformability properties in existing masonry by use of thin, bladder-like flatjack devices that are installed in cut mortar joints in the masonry wall. This test method provides a relatively non-destructive means of determining masonry properties.

Note 1: Solid-unit masonry is that built with stone, concrete, or clay units whose net area is equal to or greater than 75 % of the gross area.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 91.060.10
Nederlandse titel Standard Test Method for In Situ Measurement of Masonry Deformability Properties Using the Flatjack Method
Engelse titel Standard Test Method for In Situ Measurement of Masonry Deformability Properties Using the Flatjack Method

Winkelwagen

Subtotaal:

Ga naar winkelwagen