Norm

ASTM C1604/C1604M-05(2012)

Standard Test Method for Obtaining and Testing Drilled Cores of Shotcrete

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie C09.46
Gepubliceerd op 01-04-2012
Taal Engels

1.1 This test method covers obtaining, preparing, and testing cores drilled from shotcrete for length, compressive strength, or splitting tensile strength determinations.

1.2 The values stated in either inch-pound units or SI units shall be regarded separately as standard. SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.3 The text of this standard references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

1.4 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 91.100.30
Nederlandse titel Standard Test Method for Obtaining and Testing Drilled Cores of Shotcrete
Engelse titel Standard Test Method for Obtaining and Testing Drilled Cores of Shotcrete

Winkelwagen

Subtotaal:

Ga naar winkelwagen