Norm

ASTM C1823/C1823M - 20 en

Standard Test Method for Shear Bond Strength of Adhered Dimension Stone

57,09 62,23 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 6
Gepubliceerd op 01-08-2020
Taal Engels

1.1 This test method is used for determining the shear bond strength of dimension stone wall or floor assembly adhered to a substrate.

1.2 This test method was developed for adhered stone applications and may be used in a laboratory or in the field.

1.3 Testing is performed on cured stone assemblies on a vertical or horizontal plane in an interior or exterior application. Load is applied to one edge of the stone. The load is applied at a specified rate until the stone assembly fails.

1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

Engelse titel Standard Test Method for Shear Bond Strength of Adhered Dimension Stone

Winkelwagen

Subtotaal:

Ga naar winkelwagen