Norm

ASTM C192/C192M-16a

Standard Practice for Making and Curing Concrete Test Specimens in the Laboratory

49,88

Over deze norm

Status Definitief
Aantal pagina's 8
Commissie C09.61
Gepubliceerd op 01-06-2016
Taal Engels

1.1 This practice covers procedures for making and curing test specimens of concrete in the laboratory under accurate control of materials and test conditions using concrete that can be consolidated by rodding or vibration as described herein.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (Warning—Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to exposed skin and tissue upon prolonged exposure.2)

Details

ICS-code 91.100.30
Nederlandse titel Standard Practice for Making and Curing Concrete Test Specimens in the Laboratory
Engelse titel Standard Practice for Making and Curing Concrete Test Specimens in the Laboratory

Winkelwagen

Subtotaal:

Ga naar winkelwagen