Norm

ASTM C230/C230M-14

Standard Specification for Flow Table for Use in Tests of Hydraulic Cement

54,27

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie C01.22
Gepubliceerd op 01-10-2014
Taal Engels

1.1 This specification covers requirements for the flow table and accessory apparatus (Note 1) used in making flow tests for consistency of mortars in tests of hydraulic cement, such as but not limited to Test Method C1437.

Note 1: To help clarify the design of the flow table and accessory apparatus see the drawing in Fig. 1 [Fig. 2]. This drawing is for informational purposes only.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. It is permissible to use an inch-pound caliper and mold with a SI flow table or a SI caliper and mold with an inch-pound flow table. It is not permissible to mix a SI mold with an inch-pound caliper or an inch-pound mold with a SI caliper.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 91.100.10
Nederlandse titel Standard Specification for Flow Table for Use in Tests of Hydraulic Cement
Engelse titel Standard Specification for Flow Table for Use in Tests of Hydraulic Cement

Winkelwagen

Subtotaal:

Ga naar winkelwagen