Norm

ASTM C285-10(2015)e1

Standard Test Methods for Sieve Analysis of Wet-Milled and Dry-Milled Porcelain Enamel

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie B08.12
Gepubliceerd op 01-05-2015
Taal Engels

1.1 These test methods cover the determination of the fineness of frit in wet- or dry-milled porcelain enamels and other ceramic coatings for metals by means of the No. 200 (75-μm) or No. 325 (45-μm) sieve.

1.2 The two methods appear as follows:

 

Sections

 

   Method A—Referee Method
   Method B—Routine Method

 4 to 9 
10 to 14

1.3 Method A is intended for use where a referee method of higher accuracy is required, while Method B is intended to meet the needs of normal enamel plant production control operations where a rapid, simplified method of sieve testing is required. The accuracy of the simplified method has proved to be entirely adequate for this use. The simplified test, however, is not recommended where high accuracy is required.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 25.220.50
Nederlandse titel Standard Test Methods for Sieve Analysis of Wet-Milled and Dry-Milled Porcelain Enamel
Engelse titel Standard Test Methods for Sieve Analysis of Wet-Milled and Dry-Milled Porcelain Enamel

Winkelwagen

Subtotaal:

Ga naar winkelwagen