Norm

ASTM C29/C29M-16

Standard Test Method for Bulk Density (“Unit Weight”) and Voids in Aggregate

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie C09.20
Gepubliceerd op 01-02-2016
Taal Engels

1.1 This test method covers the determination of bulk density (“unit weight”) of aggregate in a compacted or loose condition, and calculated voids between particles in fine, coarse, or mixed aggregates based on the same determination. This test method is applicable to aggregates not exceeding 125 mm [5 in.] in nominal maximum size.

Note 1: Unit weight is the traditional terminology used to describe the property determined by this test method, which is weight per unit volume (more correctly, mass per unit volume or density).

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard, as appropriate for a specification with which this test method is used. An exception is with regard to sieve sizes and nominal size of aggregate, in which the SI values are the standard as stated in Specification E11. Within the text, inch-pound units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 19.060
Nederlandse titel Standard Test Method for Bulk Density (“Unit Weight”) and Voids in Aggregate
Engelse titel Standard Test Method for Bulk Density (“Unit Weight”) and Voids in Aggregate

Winkelwagen

Subtotaal:

Ga naar winkelwagen