Norm

ASTM C374-14(2015)e1

Standard Test Methods for Fusion Flow of Porcelain Enamel Frits (Flow-Button Methods)

54,27

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie B08.12
Gepubliceerd op 01-05-2015
Taal Engels

1.1 These test methods cover evaluation of the relative fusion flow characteristics of samples of a given porcelain enamel frit by comparison with an established standard for that frit.

1.2 Two test methods are included, differing only in certain details of the samples and in the apparatus and procedure for preparation of test specimens. Both test methods give equally reproducible results and provide a satisfactory basis for comparison of fusion flow of the sample with that of the established standard.

1.2.1 Test Method A employs granular particles of frit to which a bonding agent has been added. Button specimens are formed under high pressure in a hydraulic press.

1.2.2 Test Method B employs crushed, sized particles of frit to which a bonding agent has been added. Button specimens are formed in a steel mold by hand.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 25.220.50
Nederlandse titel Standard Test Methods for Fusion Flow of Porcelain Enamel Frits (Flow-Button Methods)
Engelse titel Standard Test Methods for Fusion Flow of Porcelain Enamel Frits (Flow-Button Methods)

Winkelwagen

Subtotaal:

Ga naar winkelwagen