Norm

ASTM C403/C403M-08

Standard Test Method for Time of Setting of Concrete Mixtures by Penetration Resistance

54,27

Over deze norm

Status Definitief
Aantal pagina's 7
Commissie C09.23
Gepubliceerd op 01-04-2008
Taal Engels

1.1 This test method covers the determination of the time of setting of concrete, with slump greater than zero, by means of penetration resistance measurements on mortar sieved from the concrete mixture.

1.2 This test method is suitable for use only when tests of the mortar fraction will provide the information required.

1.3 This test method may also be applied to prepared mortars and grouts.

1.4 This test method is applicable under controlled laboratory conditions, as well as under field conditions.

1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 91.100.30
Nederlandse titel Standard Test Method for Time of Setting of Concrete Mixtures by Penetration Resistance
Engelse titel Standard Test Method for Time of Setting of Concrete Mixtures by Penetration Resistance

Winkelwagen

Subtotaal:

Ga naar winkelwagen