Norm

ASTM C470/C470M-15

Standard Specification for Molds for Forming Concrete Test Cylinders Vertically

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie C09.61
Gepubliceerd op 01-02-2015
Taal Engels

1.1 This specification covers molds for use in forming cylindrical concrete specimens. The provisions of this specification include the requirements for both reusable and single-use molds.

Note 1: Sizes included are molds having diameters from 50 mm [2 in.] to 900 mm [36 in.].

1.2 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units are shown in brackets.

1.4 The following safety hazards caveat pertains only to the test method described in this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 91.100.30
Nederlandse titel Standard Specification for Molds for Forming Concrete Test Cylinders Vertically
Engelse titel Standard Specification for Molds for Forming Concrete Test Cylinders Vertically

Winkelwagen

Subtotaal:

Ga naar winkelwagen