Norm

ASTM C666/C666M-15

Standard Test Method for Resistance of Concrete to Rapid Freezing and Thawing

54,27

Over deze norm

Status Definitief
Aantal pagina's 7
Commissie C09.67
Gepubliceerd op 01-02-2015
Taal Engels

1.1 This test method covers the determination of the resistance of concrete specimens to rapidly repeated cycles of freezing and thawing in the laboratory by two different procedures: Procedure A, Rapid Freezing and Thawing in Water, and Procedure B, Rapid Freezing in Air and Thawing in Water. Both procedures are intended for use in determining the effects of variations in the properties of concrete on the resistance of the concrete to the freezing-and-thawing cycles specified in the particular procedure. Neither procedure is intended to provide a quantitative measure of the length of service that may be expected from a specific type of concrete.

1.2 The values stated in either inch-pound units or SI units shall be regarded separately as standard. The SI units are shown in brackets. The values stated may not be exact equivalents; therefore each system must be used independently of the other. Combining values from the two units may result in nonconformance.

1.3 All material in this test method not specifically designated as belonging to Procedure A or Procedure B applies to either procedure.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 91.100.30
Nederlandse titel Standard Test Method for Resistance of Concrete to Rapid Freezing and Thawing
Engelse titel Standard Test Method for Resistance of Concrete to Rapid Freezing and Thawing

Winkelwagen

Subtotaal:

Ga naar winkelwagen