Norm

ASTM C779/C779M-12

Standard Test Method for Abrasion Resistance of Horizontal Concrete Surfaces

54,27

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie C09.62
Gepubliceerd op 01-12-2012
Taal Engels

1.1 This test method covers three procedures for determining the relative abrasion resistance of horizontal concrete surfaces. The procedures differ in the type and degree of abrasive force they impart, and are intended for use in determining variations in surface properties of concrete affected by mixture proportions, finishing, and surface treatment. They are not intended to provide a quantitative measurement of the length of service that may be expected from a specific surface.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the inch-pound units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of each other.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (Warning—Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to skin and tissue upon prolonged exposure.)2

Note 1Other procedures are available for measuring the abrasion resistance of concrete surfaces in addition to the three procedures contained in this test method. Consideration should be given to Test Methods C944 and C418. The test method most closely representing service conditions should be used.

Details

ICS-code 91.100.30
Nederlandse titel Standard Test Method for Abrasion Resistance of Horizontal Concrete Surfaces
Engelse titel Standard Test Method for Abrasion Resistance of Horizontal Concrete Surfaces

Winkelwagen

Subtotaal:

Ga naar winkelwagen