Over deze norm
1.1 This test method describes a laboratory procedure for determining the softness of preformed tape sealants.
Note 1: Cone penetration methods applicable to greases and to petrolatum are described in Test Methods and . Test Method also uses a penetration technique for determining the degree of set in sash glazing compounds.
1.2 The values stated in SI units are to be regarded as standard. Temperature values are also provided (in parentheses) in degrees Fahrenheit.
1.3 The subcommittee with jurisdiction is not aware of any similar ISO standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
|Nederlandse titel||Standard Test Method for Softness of Preformed Tape Sealants|
|Engelse titel||Standard Test Method for Softness of Preformed Tape Sealants|