Norm

ASTM C873/C873M-15

Standard Test Method for Compressive Strength of Concrete Cylinders Cast in Place in Cylindrical Molds

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie C09.61
Gepubliceerd op 01-12-2015
Taal Engels

1.1 This test method covers the determination of strength of cylindrical concrete specimens that have been molded in place using special molds attached to formwork. This test method is limited to use in slabs where the depth of concrete is from 125 to 300 mm [5 to 12 in.].

1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (Warning—Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to skin and tissue upon prolonged exposure.2)

Details

ICS-code 91.100.30
Nederlandse titel Standard Test Method for Compressive Strength of Concrete Cylinders Cast in Place in Cylindrical Molds
Engelse titel Standard Test Method for Compressive Strength of Concrete Cylinders Cast in Place in Cylindrical Molds

Winkelwagen

Subtotaal:

Ga naar winkelwagen