Norm

ASTM D115 - 17 en

Standard Test Methods for Testing Solvent Containing Varnishes Used for Electrical Insulation

50,60 61,23 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 9
Gepubliceerd op 01-11-2017
Taal Engels

1.1 These test methods cover tests for solvent containing varnishes primarily intended to provide electrical, mechanical, and chemical protection for electrical equipment. These test methods include tests for control and performance as follows:

Procedure

Section

Build

38 – 42

Dielectric Strength

43 – 48

Drainage

26 – 32

Flash Point

18 – 20

Nonvolatile Matter

21 – 25

Oil Resistance

54 – 56

Preparation of Test Specimens

    7

Specific Gravity

9 – 12

Temperature Index

4950

Time of Drying

33 – 37

Varnish Compatibility

51 – 53

Viscosity

13 – 17

1.2 Where the entire test method is included in this standard, the precision and bias are not known unless given in the stated method.

1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 5.

Note 1: There is no equivalent IEC standard.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 29.035.60
Engelse titel Standard Test Methods for Testing Solvent Containing Varnishes Used for Electrical Insulation
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen