Norm

ASTM D1183-03(2011)

Standard Practices for Resistance of Adhesives to Cyclic Laboratory Aging Conditions

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie D14.80
Gepubliceerd op 01-04-2011
Taal Engels

1.1 These practices cover the determination of the resistance of adhesives to cyclic accelerated service conditions by exposing bonded specimens to conditions of high and low temperatures and high and low relative humidities. The extent of degradation is determined from changes in strength properties as a result of exposure to the test conditions (Note 1). It is recognized that no accelerated procedure for degrading materials correlates perfectly with actual service conditions, and that no single or small group of laboratory test conditions will simulate all actual service conditions. Consequently, care must be exercised in the interpretation and use of data obtained in this practice. The test condition, the number of cycles of the test condition to be used, the particular strength property to be used to determine the extent of degradation, and whether test specimens or test panels are to be used, is specified in the material specification.

Note 1—These practices/conditions are intended for use with specimens described in the approved ASTM strength test methods for adhesives as follows:

Test Methods D897, D903, D906, D950, D1002, D1062, and Method .

1.2 The values stated in SI units are to be regarded as the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 83.180
Nederlandse titel Standard Practices for Resistance of Adhesives to Cyclic Laboratory Aging Conditions
Engelse titel Standard Practices for Resistance of Adhesives to Cyclic Laboratory Aging Conditions

Winkelwagen

Subtotaal:

Ga naar winkelwagen