Norm

ASTM D1203 - 10 en

Standard Test Methods for Volatile Loss From Plastics Using Activated Carbon Methods

  • Deze norm is ingetrokken sinds 01-04-2016

45,11 54,58 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 3
Gepubliceerd op 01-11-2010
Taal Engels

1.1 These test methods cover the determination of volatile loss from a plastic material under defined conditions of time and temperature, using activated carbon as the immersion medium.

1.2 Two test methods are covered as follows:

1.2.1 Test Method A, Direct Contact with Activated CarbonIn this test method the plastic material is in direct contact with the carbon. This test method is particularly useful in the rapid comparison of a large number of plastic specimens.

1.2.2 Test Method B, Wire CageThis test method prescribes the use of a wire cage, which prevents direct contact between the plastic material and the carbon. By eliminating the direct contact, the migration of the volatile components to the surrounding carbon is minimized and loss by volatilization is more specifically measured.

1.3 The values stated in SI units are to be regarded as the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—This standard is similar in content (not technically equivalent) to ISO 176.

Details

ICS-code 83.080.01
Engelse titel Standard Test Methods for Volatile Loss From Plastics Using Activated Carbon Methods
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen