Norm

ASTM D1404/D1404M-99(2014)

Standard Test Method for Estimation of Deleterious Particles in Lubricating Grease

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie D02.G0.01
Gepubliceerd op 01-10-2014
Taal Engels

1.1 This test method covers a procedure for the detection and estimation of deleterious particles in lubricating grease.

1.2 This test method is applicable to all lubricating greases. It can also be used to test other semi-solid or viscous materials. Grease fillers, such as graphite and molybdenum disulfide, can be tested for abrasive contaminants by first mixing them into petrolatum or grease known to be free of deleterious particles.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. Within the text, the SI units are shown in brackets.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 75.100
Nederlandse titel Standard Test Method for Estimation of Deleterious Particles in Lubricating Grease
Engelse titel Standard Test Method for Estimation of Deleterious Particles in Lubricating Grease

Winkelwagen

Subtotaal:

Ga naar winkelwagen