Norm

ASTM D1640/D1640M-14

Standard Test Methods for Drying, Curing, or Film Formation of Organic Coatings

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie D01.23
Gepubliceerd op 01-12-2014
Taal Engels

1.1 These test methods cover the determination of the various stages and rates of film formation in the drying or curing of organic coatings under laboratory controlled conditions of air temperature, (low, ambient and/or elevated) and/or humidity. Procedures for assessing drying under prevailing conditions of temperature and humidity in the shop and field are also described.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 25.220.60
Nederlandse titel Standard Test Methods for Drying, Curing, or Film Formation of Organic Coatings
Engelse titel Standard Test Methods for Drying, Curing, or Film Formation of Organic Coatings

Winkelwagen

Subtotaal:

Ga naar winkelwagen