ASTM D1836-07(2013)

Standard Specification for Commercial Hexanes


Over deze norm

Status Definitief
Aantal pagina's 2
Commissie D01.35
Gepubliceerd op 01-06-2013
Taal Engels

1.1 This specification covers the range of products commonly referred to as hexanes, which find uses in the preparation of adhesives, coatings, and printing inks, as raw materials in chemical synthesis operations, and as solvents in various kinds of extraction operations.

1.2 The following applies to all specified limits in this standard; for purposes of determining conformance with this standard, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.5 For specific hazard information and guidance consult supplier's Material Safety Data Sheet.


ICS-code 71.080.10
Nederlandse titel Standard Specification for Commercial Hexanes
Engelse titel Standard Specification for Commercial Hexanes



Ga naar winkelwagen