Norm

ASTM D1857/D1857M-16

Standard Test Method for Fusibility of Coal and Coke Ash

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie D05.21
Gepubliceerd op 01-05-2016
Taal Engels

1.1 This test method covers the observation of the temperatures at which triangular pyramids (cones) prepared from coal and coke ash attain and pass through certain defined stages of fusing and flow when heated at a specified rate in controlled, mildly reducing, and where desired, oxidizing atmospheres.

1.2 The test method is empirical, and strict observance of the requirements and conditions is necessary to obtain reproducible temperatures and enable different laboratories to obtain concordant results.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3.1 All percentages are percent mass fractions unless otherwise noted.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 73.040
Nederlandse titel Standard Test Method for Fusibility of Coal and Coke Ash
Engelse titel Standard Test Method for Fusibility of Coal and Coke Ash

Winkelwagen

Subtotaal:

Ga naar winkelwagen