Norm

ASTM D1895-96(2010)e1

Standard Test Methods for Apparent Density, Bulk Factor, and Pourability of Plastic Materials

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie D20.70
Gepubliceerd op 01-01-2010
Taal Engels

1.1 1These test methods cover the measurement of apparent density, bulk factor, and where applicable, the pourability of plastic materials such as molding powders. Different procedures are given for application to the various forms of these materials that are commonly encountered, from fine powders and granules to large flakes and cut fibers.

1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—Test Method A is equivalent to ISO Method R 60 as described in the appendix. Test Method C is identical with ISO Method R 61.

5.1 Test Method A (see Note 1) covers the measurement of the apparent density of the fine granules and powders that can be poured readily through a small funnel.

8.1 Test Method B covers the measurement of the apparent density of coarse, granular materials, including dice and pellets, that either cannot be poured or that pour with difficulty through the funnel described in Test Method A.

11.1 Test Method C (see Note 1) covers the measurement of the apparent density of materials supplied in the form of coarse flakes, chips, cut fibers, or strands. Such materials cannot be poured through the funnels described in Test Methods A and B. Also, since they ordinarily are very bulky when loosely poured and since they usually are compressible to a lesser bulk, even by hand, a measure of their density under a small load is appropriate and useful.

Details

ICS-code 83.080.01
Nederlandse titel Standard Test Methods for Apparent Density, Bulk Factor, and Pourability of Plastic Materials
Engelse titel Standard Test Methods for Apparent Density, Bulk Factor, and Pourability of Plastic Materials

Winkelwagen

Subtotaal:

Ga naar winkelwagen