Norm

ASTM D1896/D1896M-10

Standard Practice for Transfer Molding Test Specimens of Thermosetting Compounds

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie D20.09
Gepubliceerd op 01-08-2010
Taal Engels

1.1 This practice covers a general procedure for the transfer molding of mechanical and electrical test specimens of thermosetting molding materials.

Note 1—The utility of this practice has been demonstrated for the molding of thermosetting molding compounds exhibiting intermediate viscosity non-Newtonian flow.

1.2 The values stated in either SI or inch-pound units are to be regarded separately as standard. The values stated in each system are not always exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems can result in nonconformance with this practice.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 2—There is no known ISO equivalent to this standard.

Details

ICS-code 83.140.99
Nederlandse titel Standard Practice for Transfer Molding Test Specimens of Thermosetting Compounds
Engelse titel Standard Practice for Transfer Molding Test Specimens of Thermosetting Compounds

Winkelwagen

Subtotaal:

Ga naar winkelwagen