Norm

ASTM D1921-12

Standard Test Methods for Particle Size (Sieve Analysis) of Plastic Materials

54,27

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie D20.70
Gepubliceerd op 01-08-2012
Taal Engels

1.1 These test methods cover the measurement of the particle size of plastic materials in the powdered, granular, or pelleted forms in which they are commonly supplied. As these test methods utilize dry sieving, the lower limit of measurement is considered to be about 38 ??m (No. 400 sieve). For smaller particle sizes, sedimentation test methods are recommended.

1.2 Two test methods are described:

1.2.1 Test Method A???This test method uses multiple sieves selected to span the particle size of the material. This method is used to determine the mean particle diameter and particle size distribution.

1.2.2 Test Method B???This test method is an abbreviated version of Test Method A conducted with a few specific sieves. This test method determines ???percent passing??? or ???percent retained??? on a given sieve. Test Method B is applicable to materials which do not have a normal particle size distribution such as pellets and cubes.

1.3 The values stated in SI units shall be considered standard for dimensions of the wire cloth openings and the diameter of the wires used in the wire cloth. The values stated in inch-pound units shall be considered standard with regard to the sieve frames.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1???There is no known ISO equivalent for this test method.

Details

ICS-code 19.120
Nederlandse titel Standard Test Methods for Particle Size (Sieve Analysis) of Plastic Materials
Engelse titel Standard Test Methods for Particle Size (Sieve Analysis) of Plastic Materials

Winkelwagen

Subtotaal:

Ga naar winkelwagen