ASTM D2103 - 10 en

Standard Specification for Polyethylene Film and Sheeting

  • Deze norm is ingetrokken sinds 01-04-2015

50,60 61,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 5
Gepubliceerd op 01-04-2010
Taal Engels

1.1 This specification covers the classification of polyethylene film and sheeting up to 0.3 mm (0.012 in.) in thickness, inclusive. The film or sheeting may contain additives for the improvement of the surface properties, pigments, or stabilizers, or combinations thereof.

1.2 The values stated in SI units are to be regarded as standard. The values given in brackets are for information only.

1.3 The following precautionary caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 This specification allows for the use of recycled polyethylene film or resin as feedstock, in whole or in part, as long as all the requirements as governed by the producer and end user are also met (see Note 1).

Note 1—Guide D7209 describes terminology and definitions related to recycled plastics.

Note 2—There is no known ISO equivalent to this specification.


ICS-code 83.140.10
Engelse titel Standard Specification for Polyethylene Film and Sheeting
Vervangen door



Ga naar winkelwagen