Norm

ASTM D2122-16

Standard Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie F17.40
Gepubliceerd op 01-11-2016
Taal Engels

1.1 This test method covers the determination of diameter, wall thickness, and length dimensions of thermoplastic pipe. Included are procedures for measurement of the inside diameter of pipe intended to be joined by internal fittings, measurement of the average outside diameter for roundable pipe where out-of-roundness is not of primary concern, out-of-roundness measurement and measurement of the average outside diameter of non-roundable pipe, and for determining length and straightness.

1.2 This test method also includes procedures for dimensioning molded thermoplastic pipe fittings.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 23.040.20
23.040.45
Nederlandse titel Standard Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings
Engelse titel Standard Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings

Winkelwagen

Subtotaal:

Ga naar winkelwagen