Norm

ASTM D2148 - 18 en

Standard Test Methods for Bondable Silicone Rubber Tapes Used for Electrical Insulation

  • Deze norm is ingetrokken sinds 01-08-2019

50,27 60,83 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 6
Gepubliceerd op 01-11-2018
Taal Engels

1.1 These test methods cover tests for bondable silicone rubber tapes which form a sealed structure either with the application of heat (and pressure if needed) or by the process of auto-adhesion (self-fusing).

1.2 The methods appear in the following sections:

Test Method

Section

 

 

      Adhesion

3 – 10

      Bond Strength

11 – 18

      Dielectric Breakdown Voltage

19 – 26

      Hardness

41

      Length

33 and 34

      Thickness

27 – 32

      Width

36 – 40

1.3 The values stated in inch-pound units are to be regarded as standard, except for °C. The values in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement see 23.1.1.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 29.035.20
Nederlandse titel Standard Test Methods for Bondable Silicone Rubber Tapes Used for Electrical Insulation
Engelse titel Standard Test Methods for Bondable Silicone Rubber Tapes Used for Electrical Insulation
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen