ASTM D2258/D2258M-16

Standard Practice for Sampling Yarn for Testing


Over deze norm

Status Definitief
Aantal pagina's 4
Commissie D13.58
Gepubliceerd op 01-07-2016
Taal Engels

1.1 This practice describes a procedure for the division of shipments of yarn into test lots and the sampling of such lots for testing.

1.1.1 This practice can be used for lot sample testing of yarns for both pre-fabric production and post-fabric production.

1.2 This practice is applicable to single, plied, or cabled yarns, and cords, made of any fiber or mixture of fibers, and supported on any form of package, including beams.

1.3 This practice also describes procedures for the sampling of yarn(s) removed from woven or knitted fabrics; however, when thus sampled, the yarns are usually not representative of entire shipments, as referred to in 1.1. Consequently, the resultant sampling can only be used to determine the characteristics of the yarn and is usually not used for acceptance testing. Moreover, it should be recognized that the characteristics of yarns from fabrics may be different than the characteristics of the same yarn(s), prior to being entered into the fabric manufacturing process.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


ICS-code 59.080.20
Nederlandse titel Standard Practice for Sampling Yarn for Testing
Engelse titel Standard Practice for Sampling Yarn for Testing



Ga naar winkelwagen