Norm

ASTM D2290-16

Standard Test Method for Apparent Hoop Tensile Strength of Plastic or Reinforced Plastic Pipe

50,47

Over deze norm

Status Definitief
Aantal pagina's 10
Commissie F17.40
Gepubliceerd op 01-08-2016
Taal Engels

1.1 This test method covers the determination of the comparative apparent tensile strength of most plastic products utilizing a split disk or ring segment test fixture, when tested under defined conditions of pretreatment, temperature, humidity, and test machine speed. This test method is applicable to reinforced-thermosetting resin pipe regardless of fabrication method. This test method also is applicable to extruded and molded thermoplastic pipe.

Procedure A is used for reinforced-thermosetting resin pipe; Procedure B is used for thermoplastic pipe of any size; Procedure C is used for thermoplastic pipe with nominal diameter of 41/2 in. (110 mm) and greater. Procedure D is used for polyethylene pipe with a nominal diameter of 14 in. (350 mm) and greater and preferably having wall thickness 1 in. (25 mm) and greater. Procedure E is used for polyvinyl chloride (PVC) pipe with a nominal diameter of 14 in. (350 mm) and greater and having wall thickness 1 in. (25 mm) and greater.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 83.120
Nederlandse titel Standard Test Method for Apparent Hoop Tensile Strength of Plastic or Reinforced Plastic Pipe
Engelse titel Standard Test Method for Apparent Hoop Tensile Strength of Plastic or Reinforced Plastic Pipe

Winkelwagen

Subtotaal:

Ga naar winkelwagen