ASTM D244-09

Standard Test Methods and Practices for Emulsified Asphalts


Over deze norm

Status Definitief
Aantal pagina's 9
Commissie D04.42
Gepubliceerd op 01-06-2009
Taal Engels

1.1 These test methods and practices, given under the headings titled Composition, Consistency, Stability, and Examination of Residue, cover the examination of asphalt emulsions composed principally of a semisolid or liquid asphaltic base, water, and an emulsifying agent. The test methods cover the following tests and practices:

Water Content4-10
Residue and Oil Distillate by DistillationSee Test Method
D 6997
Residue by EvaporationSee Test Method
D 6934
Particle Charge of Cationic Emulsified AsphaltsSee Test Method
D 7402
Viscosity (Saybolt Furol)See Test Method
D 7496
DemulsibilitySee Test Method
D 6936
SettlementSee Test Method
D 6930
Cement MixingSee Test Method
D 6935
Sieve TestSee Test Method
D 6933
Aggregate CoatingSee Practice
D 6998
Miscibility with WaterSee Test Method
D 6999
FreezingSee Practice
D 6929
Coating Ability and Water Resistance11-18
Storage Stability of Asphalt EmulsionSee Test Method
D 6930
Examination of Residue19-26
Identification Test for Rapid Setting Cationic Emulsified Asphalt 27-34
Identification of Cationic Slow Set EmulsionsSee Test Method
D 7402
Field Coating Test on Emulsified Asphalts35-40
Emulsified Asphalt/Job Aggregate Coating Test41-46
Density of Emulsified AsphaltSee Test Method
D 6937
Residue by Low-Temperature Vacuum DistillationSee Test Method
D 7403

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

4.1 This test method covers the procedure for determining the water content of an emulsified asphalt by reflux distillation using a water trap.

11.1 This test method is intended to aid in the identification of asphalt emulsions suitable for mixing with coarse graded calcareous aggregates. It can be applied to other aggregates. (See Note 2).

19.1 Tests for specific gravity, ash content, solubility in trichloroethylene, penetration, ductility and float test are suggested for examination of the emulsified asphalt residue obtained by distillation or evaporation (see Test Method D 6934 and Test Method D 6997).

27.1 This practice covers a procedure for identifying rapid-setting cationic emulsified asphalts. Their inability to coat a specific silica sand distinguishes them from medium and slow setting cationic grades.

35.1 This is a quick field test method to ascertain the compatibility of an emulsified asphalt with the job aggregate.

41.1 This practice may be used to identify the adequacy of slow setting grade of emulsified asphalt to mix with and coat a dense and fine-graded job aggregate. It is a laboratory practice of screening emulsified asphalt candidates for mixing with and coating job aggregates and is not to be construed as a mix design test method.


Nederlandse titel Standard Test Methods and Practices for Emulsified Asphalts
Engelse titel Standard Test Methods and Practices for Emulsified Asphalts



Ga naar winkelwagen